A translation layer could be used, no? Check api version, translate any v1 specific calls into their v2 counterparts, then submit the v2 request?

smartmontools has some good functionality for interfacing with SMART via usb bridges that do not provide native functionality.

1.2l water

240ml sodium sulfate

60ml sodium chloride

20ml xantham gum(optional for increased efficacy by keeping the solution homogenous)

Boil water, stir until fully dissolved, a small amount of solute should remain, if not, increase sodium sulfate concentration slowly until it does, indicating no free water molecules available for dissolution.

Solution should now be cooled to below 18c( freezing point) for an end product that will regulate temperature to 18c so long as it have sufficient(negative) thermal energy.

Solution of pure sodium chloride will have freezing point approx -20C, while solution of pure sodium sulfate has freezing point +35C. Adjusting the ratio of NaCl to Na2SO4 will shift the freezing point towards either end of thag spectrum, depending on what phase change temperature you are targetting.

This is actually how I do things when working on remote machines. I have far too many monitors, so dedicating on of them to a handful of btop/nvtop terminals works pretty well.

I admit that it’s a less than perfect setup though, and a single program which could handle the remote connections internally and display an aggregate would be nice.